made a crank holding tool for 2g if anyone wants to borrow

I dunno if it'll work for a 1g too, I imagine so.. it's like the one of vfaq, but thicker, heavier, uglier and much more rusty, it was a bitch to make because of those characteristics, a lot of hammering.. it's designed to hold the crank sprocket right at #1 TDC.. I don't know if the vfaq one does? otherwise it would need a hole for the guide pin on the sprocket... unless the 2g air conditioning bracket mount is somwhere else on a 1g, I dunno. Anyway if anyone needs it just let me know... after tomorrow I'll have the tensioner tool aswell.. anyone know where to buy some m8 1.25 ready rod? canadian tire only has imperial crap.. no metric.. I'd prefer not to have to go all the way to home depot..