Timing tools

[Dan Silburn]

Does anyone have a set I could borrow?

[Shane Sawatzki]

what tools do u need? you can get thru the job without any special tools... if youve done it a few times

[CamWeiss]

I believe there's one for the tensioner. The one that you can make out of your battery hold down.

[Shane Sawatzki]

yah the little pulley with the 2 holes on it... iv always just tightened the lock nut up so its snug then used a long punch and a hammer to tap up , which in my experience the 2 little holes on the pulley usually end up on the top side of the pulley, when u do this all you have to do is tighten the nut after using the punch and hammer and the tension is set and tighten it down its pretty easy to do if u cant find the tool i can show u when u get to that point dan if u end up not finding the tool

[Dan Silburn]

Sounds good ill probably end up taking you up on that.

[John Hartman]

I also make and sell the tensioner tool 

I know its just a long bolt, but I take my time on them and weld them nicely togeather.  Rounded tip, re threaded so it fits the car well.

$12 shipped.