we're putting out a feeler for those that might be intersted in joining a small
''group buy'' on throttle body boring services. this would take your 1g turbo 60mm tb and effectively bore it to 63mm HOWEVER a new thinner SS throttle plate is used along with a SS half shaft thats been shaved down. the combined effect overall is a tb that flows the same cfm as a 65mm tb. typical gains are 10-15whp depending on setup/tuning. for those with a 2g, there is a 57mm boring service - please email us if interested.
we currently have 3-4 customers what will be getting this service done which will be happening
WITHIN THE NEXT 2 WEEKS!. for those thinking that they have to take their car off the road and wait to get their tb back, we are sending some spares down. you can come in to put a deposit down and when the tb comes back from maching, just pay the balance and give us your stock 1g turbo tb. we take care of all the shipping, duties, paper work,ect.
if there are any questions or someone wants to be apart of this, please email the shop at
racing_greed@hotmail.comRG Cost:only $235 CAD + hst
Whats Done:Receive, Clean & Inspect
Beadblast
Test Sensors & Closed Throttle Switch
Machine Bore to 63mm
Modify Throttle Shaft (Half Shaft Mod)
Mfr & Install Throttle Plate
Install Plate with Stainless Button head screws Loctited in place
Replace Shaft Seals (tested to hold 30+psi! 50% thicker than stock)
New Biss screw & O-Ring,
Install New FIAV gasket.
