Readings on my SAFC (sensor check)

[Matt Mann]

My car has been parked for about 2 months because CEL and stalling and  leaking ecu as the culprit, so today I had to move my car on my property so it was more out of the way. I had kept the ecu indoors and so I plugged it in and it took a few tries to start, but after the third attempt she started and was running fine, like nothing was wrong. I move the car and decide to look at the sensor check of my SAFC and it reads as follows:

In1: 0.015-0.020
In2: 0
Thrt: 0.565-0.580

I installed this in my car about 5 years ago and did the O2 check mod but I don`t remember input 2 ever reading 0 voltage. What is it for again? O2?

Thanks

[John Hartman]

what are In1 and In2 set to monitor?

I would guess that Thrt is for the TPS, and judging by those numbers its set a little bit off, but not really far.  Its supposed to be 0.48-0.52v at idle

[Matt Mann]

I can`t remember what it was set to monitor....sorry that is not very helpful

I know I used RRE settings.
http://www.roadraceengineering.com/newafcsetting.htm