Boost creep / idk wtf overboosting

[Willem Kelly]

So I have finally been able to eliminate all the boost leaks and I'm able to boost like 25+psi on a 14b. I thought maybe my MBC was at fault so I switched back to the original 2-port BCS and setup ECMLink to handle the boost (with boost pill) but it's still going nuts.

I checked the wg actuator on the 14b and can pull it with a bit of might so I assume that's functional... Is there a procedure for this or something? Anyone have a spare WG for a TD05h?

[KevinBuckham]

Pull the line to the waste gate actuator and apply some compressed air to it (regulated to about 20 PSI).    20 PSI should be more than enough to move the wastegate arm.

[Willem Kelly]

Pull the line to the waste gate actuator and apply some compressed air to it (regulated to about 20 PSI).    20 PSI should be more than enough to move the wastegate arm.

Line to wastegate had a crack near the nipple of the wastegate ty sir. Fixed