British Columbia DSM

GVRD - BC DSM Club => Newbie Corner => Topic started by: Jovan Ceklaj on September 06, 2003, 09:30:11 pm

Title: pre existing support
Post by: Jovan Ceklaj on September 06, 2003, 09:30:11 pm

Here is a list of pre-existing resources that have VFAQs/FAQs and the like for anyone that doesn't know where to start looking.  I know I'm missing tons, so feel free to add on :)

http://www.dsm.org/
http://www.vfaq.com/
http://members.shaw.ca/costall/1000Q/
http://www.plymouthlaser.com/
http://www.geocities.com/chmwatson/FAQs/mbc.html

http://members.shaw.ca/dsm.1000q/Engineprimer
This link has been stated before, but now it's in your face!

http://www.geocities.com/MotorCity/Downs/7678/dsmtests.html
Test procedures for CELs. Huzah!

http://www.alltrac.net/manuals/
This is a guide for some Japanese products (SAFC, VPC, etc) that you may have and not have the manual for.
 
Now there is no excuse for noob questions :P

Jovan

Title: pre existing support
Post by: John Hartman on September 07, 2003, 03:43:01 pm

http://www.vfaq.com/TMO/ (good tuning page with links, using TMO logger)

http://www.roadraceengineering.com/SiteMap.htm (Complete site map of thier page, has tech, upgrades etc)

http://www.miata.net/garage/tirecalc.html (Tire size calculations)

http://www.plymouthlaser.com/safc.htm (install that SAFC into a 1g)

http://www.4g61t.org/phpBB2/viewtopic.php?p=85155&sid=512d3c5ba61500d7ff6dbfcd6af20162  (VERY helpful page on what each Mitsu ECU is for, using case numbers, scroll down a bit for a huge list)

http://www.sdsefi.com/tech.html  This is a link from a standalone EFI system page, they make thier own low cost EFI setup for racing, but the author is VERY knowledgable about tuning, turbos, fabrication etc and has put togeather a tech section.  There are some VERY good articles in here from basic to very fancy.

http://forums.evolutionm.net/showthread.php?t=262346&highlight=ams+bosch+044  Fuel pump flow rates, with some different layouts and setups, newer than the one from RRE.

http://www.inliners.org/tech/tech6.html  This is a link to a great way to find electrical shorts.

http://www.fastcoolcars.com/hp_calculator.htm  Nice, simple accurate hp calculator.  Not all wheel drive specific, so awd guys may be slightly under rated on this one.

http://www.hotrodcoffeeshop.com/forum/viewtopic.php?t=72  Wiring diagrams

/edited for dead links, added some new links/

Title: pre existing support
Post by: Chris Andrews on March 31, 2004, 09:29:42 pm

Don't forget GOOGLE (http://www.google.com).   It is your friend.  Its pretty fast, too....... 8)

Title: pre existing support
Post by: Andrew Steele on July 19, 2004, 11:46:07 pm

PROVEN UPGRADE PATHS FOR YOUR DSM

1G (90-94) Turbo Upgrade path
Performance: http://www.dsmtuners.com/tuning-guide/1gturbo/
Suspension: http://www.dsmtuners.com/tuning-guide/1gturbo/suspension.php

2G (95-99) Turbo Upgrade path
Performance: http://www.dsmtuners.com/tuning-guide/2gturbo/
Suspension: http://www.dsmtuners.com/tuning-guide/2gturbo/suspension.php

1G NON TURBO Upgrade path
Performance: http://www.dsmtuners.com/tuning-guide/1gnt/
Suspension: SAME AS TURBO

2G NON TURBO Upgrade path
Performance: http://www.dsmtuners.com/tuning-guide/2gnt/
Suspension: SAME AS TURBO


The above data was contributed by DSMTuners.com

Title: Re: pre existing support
Post by: Ivan Josipovic on December 08, 2007, 07:22:10 pm

For the N/A guys there is
www.2gnt.com

Title: Re: pre existing support
Post by: John Hartman on December 16, 2010, 03:09:41 pm

Thanx to Kevin S for this link, and for Remi to help clear up the path.

Very good 2g tire/wheel fitment faq, with pics etc.

http://www.martincheck.com/ (http://www.martincheck.com/)