Rebuild kit?

[Andrew King]

Is there a rebuild kit for the 4g63? Ive found some online but not sure of quality imput would be great thanks guys

[Bryan Hoytema]

what are you looking for ? all seals and gaskets and , all bearings?

[Brett Haviland]

those ebay kits are for the most part, cheap Chinese shit that I wouldn't touch with a really long pole.  There are some half decent kits out there as well,  but they are not super cheap.   I would just order a OEM headgasket, Good quality sealsn (cams, crank, oil pump, front balance shaft, crank seal), and valve cover gaskets (felpro or KP or OEM), timing belt/water pump kit (gates/mitsu/GMB components/pump), pistons rings (NPR are good) , main and rod bearings (KING bearings are good) all separately.  I would also only recommend using OEM timing hydraulic tensioner and also OEM oil pump/front cover and rear main seal.

[Andrew King]

If I was to rebuild from bare block, what al would I need? Is there bolt kits? etc

[Andrew King]

http://www.ebay.com/itm/Eagle-Talon-2-0-Turbo-4G63T-Engine-Rebuild-Kit-/260694447316?fits=Make%3AEagle%7CModel%3ATalon&hash=item3cb29994d4:g:5RAAAOxy7odRzLYE&vxp=mtr



this onw mentions npr rings king bearings...

[Brett Haviland]

Okay..  ok rings and bearings are good quality.... but I probably wouldn't trust the front cover and oil pump and the pistons are probably cheapo stuff.   Same with the water pump.   A good new oem front cover will cost the amount of that kit just by itself. 

Also that kits for a 2g.  Not 1g

[Bryan Hoytema]

Ya I got a water pump kit off eBay for my Mazda and the thing crapped out at 30,000km , daily driving . No shaft play no leaks . Just the bearing started to make a shit ton of noise

[Brett Haviland]

The gmb pump Bryan? 

[Bryan Hoytema]

You'd have to look at your old purchases . Not sure what brand .

[Brett Haviland]

Yeah it was GMB,    they are good pumps. Use them at work on everything you musta tightnd the belt too much

[Bryan Hoytema]

Ya that's a possibility,